Removing (page 3 of 3)

• TO FIT
• – Assemble the steering tie rod.
• – Set the steering tie rod length, fig. I.

Dimension a = 322 mm

WARNING - We recommended that this initial adjustment is carried out to that the steering lock angles are the same on each side.

• – Tighten the lock nut finger tight, for the moment.
• – Fit the steering tie rod to the rack, fig. II.
• – Lock the ball joint casing, fig. IV, by peening the tab provided for this purpose into the slot machined in the rack.
• – Fit the ball joint boot and its two rubber rings at the steering ball joint end.
• – Fit the boot retaining clip at the steering rack end.
• – Tighten the ball joint casing, fig. III, at the rack end, to torque of 6 m.daN (60 Nm, 44 lbf ft), using spanner 8.0708.