Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


PB 150 V8-318 5.2L VIN T 2-BBL (1983)

Steering and Suspension > Steering > Power Steering > Power Steering Pump > Component Information > Service and Repair > Power Steering Pump Overhaul > Page 2907

Page 3
background image

Fig. 5 Installing driveshaft assembly

Fig. 6 Installing pump ring

Fig. 7 Installing rotor vanes

1. Lubricate new Of-ring seals with Vaseline and place in pump housing.
2. If drive shaft oil seal was removed during disassembly, lubricate new seal with Vaseline. Then install seal in pump body front hub, using a suitable

seal driver.

3. Position thrust plate and rotor on drive shaft. Then install rotor retaining ring in groove of drive shaft.

Steering and Suspension > Steering > Power Steering > Power Steering Pump > Component Information > Service and Repair > Power Steering Pump Overhaul > Page 2907

[PREV PAGE] [NEXT PAGE]