Prowler V6-3.5L VIN G (1999)
6. Loosen bolt attaching stabilizer bar attaching link to rocker arm.
7. Remove shock absorber from rocker arm.
8. Remove shock absorber from vehicle.
CAUTION: When shock absorbers are installed on this vehicle, the vehicle must be at its curb height before the shock absorber lower mounting bolts
are tightened and torqued.
INSTALL
1. Install the shock absorber.
CAUTION: When installing shock absorber into rocker arm, care must be used so the upper bushing on the shock absorber and the rocker arm
are not damaged.
2. Install the upper bushing on the shock absorber into the rocker arm. Bushing can be installed the easiest by first carefully starting the front and
back edge of the bushing into the rocker arm and then lightly tapping it into the rocker using soft faced hammer.
3. Install the shock absorber to rocker arm mounting bolt. Tighten the bolt to a torque of 163 Nm (120 ft. lbs.).
4. Tighten the stabilizer bar attaching link bolts using a flex socket and extension to a torque of 60 Nm (45 ft. lbs.).
5. Raise the vehicle on jack stands or on a frame contact type hoist.
6. Install the bolt and flag nut, mounting the removed shock absorber to the frame crossmember. DO NOT TIGHTEN THE BOLT AT THIS TIME
7. Lower the vehicle.
NOTE: When jouncing the vehicle, the vehicle must be released at the bottom of the jounce cycle. This will ensure the vehicle's suspension will
raise the vehicle to the correct curb height at the top of the jounce cycle.
8. Position the vehicle on a drive on hoist or an alignment rack so the full weight of the vehicle is supported by the suspension. Correctly jounce the
front and the rear of the vehicle to obtain the correct curb height.
9. Tighten both shock absorber lower mounting bolts to a torque of 163 Nm (120 ft. lbs.).
Rear
REMOVE
1. Raise vehicle on jackstands or centered on a frame contact type hoist.
NOTE: When removing the center cap from the wheel do not use a sharp or hard tool. Use of such a tool can mare the finish on the wheel and
