Montana V6-3.4L VIN E (2002)
Alignment: Specifications
Front
Camber
Service Allowed-Acceptable
-1.20 to -0.20°
Service Preferred- Target
-0.70°
Caster-Nominal-
Service Allowed-Acceptable
2.40 to +3.40°
No means of adjustment provided
Service Preferred- Target
2.90°
Cross Camber
Service Allowed-Acceptable
-0.75 to +0.75°
Service Preferred- Target
0°
Cross Caster-
Service Allowed-Acceptable
-0.75 to +0.75°
Nominal-No means of adjustment provided
Service Preferred- Target
0°
Total Toe
Service Allowed-Acceptable
0.20 to +0.20°
Service Preferred- Target
0°
Rear-Nominal-
Camber
Service Allowed-Acceptable
-0.75 to -1.25°
No Means of Adjustment Provided
Service Preferred- Target
-1.0°
Cross Camber
Service Allowed-Acceptable
-0.50 to +0.50°
Service Preferred- Target
0°
Total Toe
Service Allowed-Acceptable
-0.30 to +0.30°
Service Preferred- Target
0°
Rear All-Wheel Drive
Camber
Service Allowed-Acceptable
+0.35 to -0.85°
Service Preferred- Target
-0.25°
Cross Camber
Service Allowed-Acceptable
-0.60 to +0.60°
Service Preferred- Target
0°
Total Toe
Service Allowed-Acceptable
-0.20 to +0.20°
Service Preferred- Target
0°
Thrust Angle
Service Allowed-Acceptable
-0.15 to +0.15°
Service Preferred- Target
0 Degrees
Strut Lower Nuts
90 ft.lbs.
The fastener develops a specified amount of torque/drag
against its counterpart prior to the fastener seating.If
the fastener does not meet these criteria, REPLACE the
fastener.
This is a prevailing torque type fastener. This fastener
may be reused ONLY if:The fastener and its counterpart are
clean and free from rust. (Note Continue in next cell).