911 Carrera 2 Targa F6-3600cc 3.6L SOHC (1992)
Crimp two connectors, Part Number N 0172431, to one end of the paired wires and install connectors on terminals 1 and 3 of switch, Part Number 911
613 113 00.
From the above illustration, select an unused switch location on the vehicle dash board. Locate the existing hole behind fabric and carefully remove
fabric with a razor knife.
Feed switch wires through opening in dash and route with hands-free microphone cable to the right side of the center console.
Locate the 2-wire multi-plug on the Fujitsu harness and cut off the plug. Join the wires from the power switch to the two wires of the Fujitsu harness.
Insulate these connections with heat-shrink tubing.
Install switch in opening of dash. Reinstall large left instrument. Seal the inside grommet with silicone after routing cable.
8.
Mounting phone to center console
Place the cellular telephone mounting cradle, hands-free speaker, mounting bracket and screws on a table or bench.
Using the supplied mounting screws, attach the handsfree speaker to the cellular telephone mounting cradle.
Attach the mounting bracket to the hands-free speaker.
Insert the data cable from the hands-free speaker and the three pin vehicle adapter into the mounting cradle.
Install the hands-free microphone plug into the hands-free speaker jack.
Pull the "3 switch group" from the center console and remove the spoiler/PDAS switches.
