911 Targa (996) F6-3.6L (2004)
5. Installing plastic panel
a. Insert fastening clip -44a- onto the tab of the plastic panel -44- from behind and turn 90° clockwise.
b. Position plastic panel -44- on roof frame 1 -11- and screw in with the fastening screws -45-.
Tightening torque: 5 Nm (3.5 ftlb.).
Additional assembly instructions for installing tension strap as of model year 2002 (convertible top with glass window)
1. Installing tension strap and bracing strap on the tension bow
NOTE: Position the bracing strap -41a- as illustrated.
Position tension strap -41- and bracing strap -41aon the holes provided on the tension bow -21-, rivet on the tension strap -41- with the pop rivets
-43- (parts scope component of convertible-top covering)
Installing styling frame
1. Installing styling frame on roof frame 3
a. Screw on draught deflector -46- on the front face of the styling frame -48- with the fastening screw -47-.
Tightening torque: 1.7 Nm (1.0 ftlb.)
b. Position styling frame on roof frame 3 -8- and tighten with fastening screws -49-.
Tightening torque: 1.7 Nm (1.0 ftlb.)
2. Installing styling frame on roof frame 2
a. Screw on fabric guide plate -50- and styling frame -51- with the Torx screws T 15 -52- and the washers -52a-.
Tightening torque: 1.7 Nm (1.0 ftlb.)
b. Position styling frame -51- on roof frame 2 -5-. Adjust gap dimension -A = 3.1 + 0.5- between styling frames 2 and styling frame 3 -48-. Screw
on fastening screws -53- and the washers -53a-.
Tightening torque: 9 Nm (7.0 ftlb.)
Installing seals on the styling frame
1. Installing seal on styling frame (roof frame 3)
a. Position aluminium profile -54- on the styling frame -48- and screw on with the fastening screws -55-.
b. Insert the seal -56- into the aluminium profile -54-.
Tightening torque: 1.7 Nm (1.0 ftlb.)