911 Targa (996) F6-3.6L (2004)
Replacing potentiometer
1. Cut off faulty potentiometer behind the wiring of the spare potentiometer using a pair of side cutters.
-
Join wires using crimp connector and crimping tool.
-
Cut off lines to different lengths (due to the shrink connection).
-
Slide shrink-fit hose over the leads.
-
Strip 10 mm of insulation off the wires.
-
Connect wires with crimp connectors (do not confuse colours of the individual wires).
-
Shrink shrink-fit hoses with a hot-air gun. It is essential that all wires are watertight.
-
Wrap commercially available PVC tape all around the area of the connection points.
Installing potentiometer.
Installing tension strap
1. Installing tension strap on roof frame 1
Position tension strap -41- on roof frame 1 -11- and screw in with the fastening screws -42-.
Tightening torque: 5 Nm (3.5 ftlb.).
2. Installing tension strap on the main bow
Position tension strap -41- on main bow -14- on the holes provided, rivet on the tension strap -41- with the pop rivets -43- (parts scope component
of convertible-top covering)
3. Installing tension strap on the corner bow
Position tension strap -41- on corner bow -18- on the holes provided, rivet on the tension strap -41- with the pop rivets -43- (parts scope
component of convertible-top covering)
4. Installing tension strap on the tension bow
Position tension strap -41- on tension bow -21- on the holes provided, rivet on the tension strap -41- with the pop rivets -43- (parts scope
component of convertible-top covering)