911 Targa (996) F6-3.6L (2004)
4. Fit cylinder head cover (as shown in the Figure). Apply a thin bead of sealant on the cylinder head cover. The bead should not be higher than 1.5
mm.
5. Position the 20 hexagon-head bolts M6x30 on the cylinder head cover and 2 hexagon-head bolts M6x20 on the oil extraction pump.
Information
-
If the O-ring of the oil extraction pump needs to be replaced, insert the pump after fastening the cylinder head cover and then position the 4
hexagon-head bolts M6x20.
6. Tighten the 20 hexagon-head bolts in the specified tightening sequence with a torque wrench with 13 Nm (9.5 ftlb.).
Tightening torque: 13 Nm (9.5 ftlb.)
7. Tighten the 2 or 4 hexagon-head bolts M6x20 of the oil extraction pump with a torque wrench with 13 Nm (9.5 ftlb.).
Tightening torque: 13 Nm (9.5 ftlb.)
8. Position a new, dry, brown closure cap [diameter] 45 mm on the bore of the exhaust camshaft on the belt pulley side and tap it gently into place
with a plastic hammer.
9. Insert 2 green closure caps into the small bores on the clutch side. Position the dry, new closure caps and tap gently into place with a plastic
hammer.
10. Fit 2 new covers for the magnetic hydraulic valves.
11. Fit the holders for the magnetic hydraulic valves. Position 4 hexagon socket head bolts M6x20 and tighten with a tightening torque of 10 Nm (7.5
ftlb.).