911 Targa (996) F6-3.6L (2004)
-
A: Holder for camshaft adjustment valve (NVS)
-
B: Holder for valve lift adjustment valve (VVS)
12. Fit ignition coils. Insert 3 ignition coils into the spark-plug recesses. Position 2 hexagon socket head bolts M6x25 per ignition coil and tighten with
a torque wrench with 10 Nm (7.5 ftlb.).
Tightening torque: 10 Nm (7.5 ftlb.)
13. Fit holder for the main muffler. Position 4 hexagon-head bolts: top 2 M8x30, bottom 2 M8x25, then tighten with a torque wrench with 23 Nm (17
ftlb.). Connect the electrical plug of ignition coil cyl. 5 and the 2 electrical plugs of the magnetic hydraulic valves. Clamp the cables of the
hydraulic valves in the sheetmetal brackets.
Tightening torque: 23 Nm (17 ftlb.)
14. Install the shield. Insert the shield, position and tighten the 2 hexagon-head bolts M6x16.
15. Connect the 2 cable plugs on the oil temperature switch.
16. Fit the ground cable on the cylinder head. Tighten the hexagon-head bolt M8 with a torque wrench with 23 Nm (17 ftlb.).
Tightening torque: 23 Nm (17 ftlb.)
Cylinder bank 1 - 3
1. Install the cylinder head cover of cylinder bank 1 - 3 in the same way as for cylinder bank 4 - 6.