911 Targa (996) F6-3.6L (2004)
Crankshaft Main Bearing Seal: Service and Repair
Removing and Installing Crankshaft Sealing Ring - Flywheel Side
Removing and installing crankshaft sealing ring - Flywheel side
Caution:
When working on the engine, absolute cleanliness is essential. Even the smallest particles of dirt can damage engine components.
Note;
-
The sealing ring can be replaced on the installed engine in Tiptronic vehicles only up to and including model year 2001.
-
To replace the sealing ring in Tiptronic vehicles as of model year 2002, the complete engine/transmission unit must be removed.
-
In vehicles with manual transmission, the sealing ring can be changed on the engine, irrespective of whether it is installed or removed.
Tools
Note;
-
Two new tools are to be used for fitting the crankshaft sealing ring as of August 2002. These replace special tools 9609 and 9609/1.
Removing the crankshaft sealing ring
Engine removed
Note;
-
In order to avoid deforming the thrust plate housing, always loosen screws in several stages and in diametrically opposite sequence.
-
Make sure not to damage the crankshaft flange when installing and removing the double-mass flywheel or Tiptronic drive plate!