911 Targa (996) F6-3.6L (2004)
/f6-3.6l/Page-762005.png)
-
Slide the protective tube/additional spring assembly on the piston rod. Slide the cup washer No. 7 and stop plate No. 4 as far as they will go into
the correct position on the piston rod.
-
Push the pretensioned coil spring onto the vibration damper so that the end of the coil spring rests against the stop of the spring plate.
-
Place spring strut mount (assembly of mount/back-up ring/spring plate) onto the piston rod so that the end of the coil spring is located in the spring
plate. Place stop plate in the correct position on the spring strut mount and screw a new fastening nut onto the piston rod. Make sure that the
rubber part of the mount is properly seated in the recess in the spring strut mount (arrows).
-
Use a socket wrench insert open on one side to tighten the fastening nut on the spring strut mount. In this way the specified tightening torque can
be adhered to exactly. It is also possible to counter at the piston rod with special tool 9630 at the same time. Never use an impact bolter to tighten
the fastening nut.
