911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
2. Insert brake pedal into mounting block.
-
If necessary, fit a shim (arrow) between the brake pedal and the mounting block (to compensate for the axial play).
-
The shim is not always present.
-
When replacing the mounting block or the brake pedal, determine the thickness of the shim (if present and/or required):
With the brake pedal installed, determine by trial and error which shim can be inserted.
-
There are shims with two different thicknesses available.
-
Insert bearing tube No. 11.
-
Insert screw No. 10, but do not tighten it yet.
-
Important: Tighten screw No. 10 only after installing the pedals.
3. Preassemble lever No. 9, rocker No. 16 and connecting pieces No. 13.
-
If necessary (after installation of a new rocker), turn adjustment screw No. 17 until the leg of the servo spring fits closely to the rocker (arrow).
-
Install only levers No. 9 with optimized kinematics.
-
See note for step 8 of disassembly above.
4. Insert bearing sleeve No. 5, servo spring No. 6 and the assembly of lever No. 9 and rocker No. 16 into the mounting block.
-
Insert and fasten shaft No. 7.
5. To preload the servo spring, mount the brake pedal of the completed pedal system onto a vise, using protective jaws.