911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
New (with centering - arrows)
Old (without centering)
For repairs where spare parts are needed and where the customer has complained of vibrations at 180 to 200 kph, only parts (drive shafts or caps and
halfshaft flanges) with centering (arrows) must be used. With these parts, the runout checks on the drive shafts are no longer required.
The old drive shafts without centering may be converted to centering by fitting the new cap.
If new drive shafts or old drive shafts with new caps are used, the new halfshaft flanges with internal fitting must also be fitted to the front axle final
drive unit.
CAUTION:
-
When installing the cap, the sealing surface against the joint must be sealed using sealing gel (000.043.203.47) (arrow).
-
The sealing gel must also be used on the caps of the rear axle drive shafts.
For further information (allocation/part nos.) refer to Technical Information.
