911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
4. Release fastening screws of connector unit/grounding cable and speed sensor from wheel carrier (arrow).
-
Unclip lines from wheel carrier (No. 1) and parking brake cable.
-
Remove speed sensor.
5. Remove brake caliper from wheel carrier and hang it up in wheel arch.
6. Disconnect stabilizer mount from stabilizer (holding open jaw wrench against bolt).
-
Remove stabilizer clamp.
NOTE:
-
The stabilizer mount must remain attached to the spring strut.
-
The stabilizer must not be removed.
7. Dismantle parking brake cable as follows:
-
Remove cassette box and trim panel above parking brake lever.
-
Loosen and completely unscrew lock nut and adjustment nut (No. 1) from arm (No. 2).
-
Remove safety clip (No. 3) from support pin (No. 4) of parking brake lever and remove support pin.
-
Remove parking brake lever (with arm)
-
Unhook tab washer (No. 5) for parking brake cables from retaining lug (No. 6) - at top and bottom.
-
Unhook appropriate parking brake cable and pull it out of the guide from the back.
8. Remove control arm 2 (toe control arm).
CAUTION:
-
Before loosening the bolts, mark the position of eccentric bolt A for installation, so that a complete measurement of vehicle alignment is not