911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
NOTE:
-
As considerable force is needed to move the drive shaft in the teeth of the wheel hub, loosen the drive shaft using a copper drift.
-
With unfavorable tolerances, it may be necessary to push the drive shaft out of the hub using a wheel hub puller (e.g. a Klann or Schrem tool).
-
On the 911 Turbo, a ventilation tube is inserted in the joint on the wheel.
-
To prevent damage to the ventilation pipe when pressing the drive shaft out of the wheel hub, insert a pressure piece, e.g. VW 295A, between
the puller spindle and the drive shaft.
-
At this stage, it is not yet possible to pull the drive shaft out completely.
3. Remove cover from control arm 1 & 5 (unclip).
-
Remove heating pipe (No. 1).