911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
4. Remove heating pipe (No. 1).
5. To prevent damage to the drive shaft, place a protective tube on the drive shaft (arrow).
-
Unbolt drive shaft from transmission flange (pan head screws) and pull out drive shaft.
-
If necessary, pull the vehicle down slightly onto the springs to pull the drive shaft out.
Installation Left Drive Shaft
1. To install the drive shaft, proceed in reverse order.
-
Carry out a visual inspection of all parts before starting installation.
-
Grease the drive shaft teeth with Optimoly HT.
-
Insert the drive shaft.
2. Tighten drive shaft on transmission flange and wheel hub.
-
Use new fastening nut.
-
Comply with torque specifications.
3. Install cover of control arm 1 & 5 and the underside guards and panels.
Right Side Rear Drive Shaft
NOTE:
With regard to rear drive shaft removal and installation, there are considerable differences in the configuration between transmission types and the
sides of the vehicle. Separate procedures are therefore given.
Removing And Installing Right Drive Shaft
1. Remove rear wheel, engine guard from engine/transmission and rear underside panel.
2. Loosen drive shaft from wheel.
-
When doing so, also apply the brakes.
