911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
6. Unscrew fastening screws -3- and remove hardtop locking mechanism -2- from hardtop body.
Installing the rear hardtop locking element
Installing rear hardtop locking mechanism
INFORMATION: Only for removal of the rear left hardtop locking mechanism.
1. Position hardtop locking mechanism -2- on the hardtop body and screw down with the fastening screws -3-. Tightening torque: 10 Nm (7.5 ftlb.)
2. Screw in fastening screw -1- for rear hardtop locking mechanism by hand and then tighten to specified tightening torque, Tightening torque: 46
Nm (34 ftlb.).
3. Check fastening clips, replacing if necessary. Clip in trim panel -1-.