911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Information
Always replace fastening nuts
18. Fit and tighten three new M8 fastening nuts. - Tightening torque: 23 Nm (17 ftlb.)
Collar nuts on oil pump
19. Check connecting shaft. The connecting shaft must move freely in axial direction. Loosen the oil pump with intermediate shaft again if necessary
and shift the connecting shaft.
Connecting shaft between oil pump and intermediate shaft
20. Prepare the through bolts for installation. The diagram shows the through bolts already fitted on the designated thrust blocks.
O-rings and inner through bolts
Information
Additional O-rings are inserted on four through bolts on the thrust block mount, thrust blocks 2, 3, 4 and 5.
The four through bolts must be fitted before joining the crankcase halves.
Information
Do not oil sealing rings until shortly before fitting.