911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Do not store oiled sealing rings.
21. Prepare four through bolts. Slide sealing washers onto the through bolts. Guide lightly oiled O-rings with conical sleeve from special tool assembly
sleeve 9511 over the threaded area and push them on to the conical section towards the head of the bolt.
Preparing through bolts for assembly
22. Observe the A and B side on the assembly sleeve 9511.
Special tool assembly sleeve 9511
23. Insert the prepared through bolts as far as they will go into the right crankcase half from below and hold at this position.
Inserting through bolts
24. Fit conical sleeve on the end of the thread. Slide dry O-ring over the conical sleeve. Remove conical sleeve and push the O-ring with the cylinder
sleeve as far as the chamfer in the thrust block. Remove cylinder sleeve.