911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
1. Release the cable retainer -arrow A- and pull off the two connectors -arrow B-.
2. Unscrew the fastening screw and remove the connector socket -arrow C-.
3. Remove the ABS wire harness from the brackets -arrows A-.
4. Open the clips -arrows B- and remove the ABS wire harness -arrow C-.
5. Remove the fabric tape -D-.
INFORMATION: When cutting the ABS wire harness, make sure that there is enough line length left to join to the new lines.
6. Cut off the ABS wire harness around -E- and remove it.
7. Cut through the fabric tape in the plenum panel, in the area around -a-, and expose the remaining ABS lines.
Removing rear ABS wire harness