911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
8.2.
Fit diagonal arm -17- on the rear-axle carrier side section -1-. To do this, screw in (fit) bolts -18, 19-.
9. Tighten the rear axle.
Observe prescribed tightening sequence so as not to twist the rear axle.
Rear-axle carrier side section
9.1.
Tighten front rear-axle carrier side section -7- at the left and right.
Stud -4- securing rear-axle carrier side section to body (front)
-
Tightening torque: 46 Nm (34 ftlb.)
Lock nut -7- securing rear-axle carrier side section to body (front)
-
Tightening torque: 110 Nm (81.5 ftlb.)
9.2.
Tighten rear rear-axle carrier side section -6- at the left and right.
9.3.
Tighten center rear-axle carrier side section -5- at the left and right.
Rear-axle carrier side section to body (center and rear) -5 and 6-
-
Tightening torque: 110 Nm (81.5 ftlb.)
Cross member
9.4.
Tighten cross member -14- to carrier side section at the bottom left/right first, then at the top left/right.
-
Tightening torque: 110 Nm (81.5 ftlb.)
9.5.
Tighten diagonal brace to the body -12- at the left and right.
-
Tightening torque: M10=65 Nm (48 ftlb.)
-
Tightening torque: M12=110 Nm (81.5 ftlb.)