911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Plug-in coupling
Subsequent work
1. Install starter (manual transmission).
Starter (manual transmission)
2. Set the pressure accumulator in place and twist it into position using an oil filter strap. Use an open-ended wrench to tighten the pressure
accumulator (tightening torque: 30 Nm/22 ftlb.). - Tightening torque: 30 Nm (22 ftlb.).
Pressure accumulator
3. Fit holder for the coolant lines on the transmission (underneath the pressure accumulator). Clip coolant lines into the holder on the underside of the
transmission.
4. Fit the left drive shaft on the transmission flange. - Tightening torque: 90 Nm (67 ftlb.).
5. Install (front) transverse strut. Tightening torque for fastening screws -arrows-. - Tightening torque: 65 Nm (48 ftlb.).
Installing transverse strut
6. Install rear underbody panelling.
7. Connect the battery and perform the necessary subsequent work.