911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Selector force mechanism
A - Stud
B - Circlip
C - Lid
2.1.
Screw out stud -A-.
2.2.
Remove circlip.
Remove circlip -B- using a circlip pliers.
2.3.
Drill a hole into the center of the lid -C-.
Drill a 3.5-mm hole into the center of the lid -C- (coat the drill bit with viscous grease to prevent drill chips from falling into the transmission).
2.4.
Screw in tapping screw.
Levering out lid
Screw in tapping screw (4.8 x 25) with a large washer.
2.5.
Lever out lid using two screwdrivers.
Installing lid for selector force mechanism
1. Install lid for selector force mechanism.