911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Selector force mechanism
A - Stud
B - Circlip
C - Lid
Replace lid for selector force mechanism!
1.1.
Insert lid -C- and circlip -B- into the housing bore.
1.2.
Move lid -C- and circlip -B- into position.
Press circlip and lid down using a press-out mandrel p 375 until the circlip engages in its groove.
Information
^
Make sure that the circlip is seated correctly.
1.3.
Screw in and tighten studs -A-.
-
Tightening torque: 23 Nm (17 ftlb.)
Subsequent work
1. Install engine-transmission unit.