924 S L4-2479cc 2.5L (1986)
5. Move release lever until needle bearing and bore in clutch housing align.
-
Slide in release lever shaft positioned correctly so that machined surface faces mounting bolt against stop. If necessary, move release lever back
and forth - but never use force!
6. Screw in mounting bolt for a correctly installed release lever shaft and lock with nut. Tightening torque = 9.5 Nm (7.0 ft lb)
7. Bolt clutch housing, cover and, if applicable, right support. Tightening torque = Clutch housing 75 Nm (55.3 ft lb) Right support 42 Nm (30.9 ft
lb) Connect starter wire harness. Mount start and reference mark sensors as well as ground wires on clutch housing and body. Tightening torque =
8 Nm (5.9 ft lb)
8. Check that insulation sheet on central tube is still positioned correctly. Distance from flange inside to insulation should be 500 mm (20 in.).
9. Push central tube forward and bolt to clutch housing. Guide central tube with drive shaft into clutch housing and clutch disc carefully (danger of
