Boxster S (987) F6-3.4L (2008)
Installing convertible top support
1. Place convertible top support -1- on roll-over bar from outside -2-, position it correctly and screw down with the three fastening screws -3-.
Tightening torque: 23 Nm (17 ftlb.)
Installing main folding top bow
1. Press Teflon sleeves -1- at both sides into the bores on the main folding top bow -2-.
2. Position main folding top bow on convertible top support -3- and join with the pin -4- (8 x 70 mm) -arrow-.
3. Press retaining clip -5- into the pin.
Connecting control arm and lower lever with B-pillar
1. Press Teflon sleeves -1- at both sides into the bore on the control arm -2-.
2. Position control arm -2- on lever -3- and join with the pin -4- (8 x 25 mm) -arrow-.
3. Press retaining clip -5- into the pin.
4. Press Teflon sleeves -1- at both sides into the bores on the lower lever -2-.
5. Position control arm and lower lever on B-pillar -3- and join with the pin -4- (8 x 30 mm) -arrow-.
6. Press retaining clip -5- into the pin.