Boxster S (987) F6-3.4L (2008)
12. Push engine compartment temperature sensor and rubber sleeve into bracket (only if removing intake-air distributor on cylinders 1-3). Grease
rubber sleeve lightly with Optimol MP0 or silicon spray.
13. Position rubber sleeves with screw-type hose clamps.
14. Tighten screw-type hose clamps -arrows- on resonance tube.
Work subsequent to installing intake-air distributor
Subsequent work for installing intake distributor
1. If the intake-air distributor for cylinders 4-6 was removed, install the air-cleaner element again.
2. Install throttle housing with distributor pipe.
3. Install engine compartment lid.
4. Read out fault memory and correct any faults that are present.