Boxster S (987) F6-3.4L (2008)
7. Remove intake-air distributor gaskets.
8. Remove throttle body by unscrewing the four Torx screws (M6 x 50) -arrows-.
9. Pull off the seal -arrow- from the throttle body.
10. Remove cap by unscrewing the two plastic screws.
11. Loosen screw-type hose clamps -arrows- and disconnect intake-air distributor.
12. Thoroughly clean components before assembly. Do not treat the surface with strong cleaning agents.
Assembling intake-air distributor
INFORMATION: Always replace O-rings and gaskets.