Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-629039.png)
5. Push rubber sleeve back slightly -Arrow-, remove adhesive tape and pull off foil hose -A-.
6. Cut and remove tie-wraps for fixing the wire harness to the connector housing.
7. Release cap on both sides -Arrow a- and remove from the connector housing.
8. Release locking mechanism on connector housing with a small screwdriver -Arrow A- and remove it -Arrow B-.
9. Pull connector out of the connector housing -Arrow C-.
10. Release connector guide on both sides -Arrow a- and slide down from the contact strip.
INFORMATION: Allocation of lines - see wiring diagram.
