Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-629040.png)
11. Release contacts of the damaged lines using the press-out tool 1575-1P of the press-out and unlocking tools for flat and round plug connections of
every size NR.155 ( -Arrow a- ) and pull out of the contact strip.
12. Cut off the contacts of the damaged lines, insulate them and secure them to the main wire harness with tie-wraps.
13. Insert wire puller -1- with the flexible end on the right side -Arrow- into the rubber sleeve -2-. Coat the wire puller -1- with soapy water and slide it
through the rubber sleeve -2- ( -Arrow A- ).
INFORMATION: Two different wire harnesses are available as spare parts, depending on the model year. Up to model year 05, the wire harness
-A- comes with insulation as standard. From model year 2006 onwards, the wire harness -B- no longer has this insulation.
INFORMATION: Observe wrapping direction of adhesive tape. To keep the resistance as low as possible when pulling the new wire harness
through, always start wrapping the tape around at the new wire harness and end at the wire puller.
14. Push new lines -2- through the eye in the back of the wire puller -1- ( -Arrow A- ), fold them over and secure with adhesive tape -3- ( -Arrow B- ).
