Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-629041.png)
15. Coat the new wire harness -2- with soapy water and use the wire puller -1- to pull it through the rubber sleeve -3- ( -Arrow A-). Push carefully on
the new wire harness at the same time to make it easier to pull the lines through.
16. Remove adhesive tape -3- ( -Arrow A- ) and carefully pull the lines -2- out of the eye on the wire puller -1- ( -Arrow B- ). Make sure that the
insulation on the new lines is not damaged.
17. Route new wire harness along the door wire harness and secure at the standard attachment points on the door sub-frame. Securing line for head
airbag at door sub-frame
18. Push on connector of new wire harness for head airbag at the left -5- and right -6- until it is felt to engage.
INFORMATION: Allocation of lines - see wiring diagram.
19. Push new lines into the contact strip until the contacts are felt to engage.
20. Push connector guide onto the contact strip until it is felt to engage.
