Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-698004.png)
screw-type clamps.
Information
Before starting to work on the PDCC system, always clean the underbody or at least clean the system components you will be working on. Ensure
absolute cleanliness at all times. In other words:
^
Clean the system components to be removed using a power washer, for example. Ensure that the high pressure spray is at least 50 cm away from
the component (risk of damage to electric lines, connectors and contacts).
^
Before loosening the hydraulic connections, the areas around the connections must also be cleaned carefully (e.g. using a brush and/or a lint-free
cloth).
^
If you intend to use the component again, the openings must be sealed immediately with suitable stoppers.
^
If you are using new components, the stoppers must only be removed immediately before fitting.
Removing rear anti-roll bar (PDCC)
Rear anti-roll bar
PDCC component arrangement
1. Mark the two lines using a touch-up stick, from the steel flexi-pipe to the anti-roll bar housing.
