Cayenne S (9PA) V8-4.5L (2003)
1.3 Remove PCM. --> Workshop Manual '911019 Removing and installing display and operator control unit (PCM2)' or
Remove car radio. --> Workshop Manual '91241900 Removing and installing car radio'
1.4 Remove center console cover. --> Workshop Manual '681919 Removing and installing cover for centre console'
1.5 Remove front air-conditioning system regulator. --> Workshop Manual '870219 Removing and installing front air-conditioning system
regulator'
1.6 Remove front ashtray. --> Workshop Manual '682019 Removing and installing front ashtray'
1.7 Remove device carrier. --> Figure 4 -A-.
1.7.1 Remove screw --> Figure 4 -B-.
1.7.2 Pull device carrier towards the rear --> Figure 4 -arrow- and plug out connector --> Figure 4 -C-.
2
Prepare connector setup in center console.
2.1 Mark bore holes in the middle if necessary. Do not exceed dimension X = 12 mm, measured from the floor. (See also --> Figure 6).
NOTE:
Remove metal shavings produced by drilling using a vacuum cleaner.
Drill two holes with a diameter of 10 mm in the center console and rework them until the connector --> Figure 6 -A- from the wire harness
(retrofit kit) can be pushed through.
NOTE:
Use a bit stop (25-mm setting) if necessary to prevent damage to underlying components.