Cayenne S (9PA) V8-4.5L (2003)
7. Disconnect the ignition coil. To do this, press the button on the plug and pull off the plug.
8. Release active ignition coil. To do this, unscrew the fastening screw on the valve cover.
9. Pull the ignition coil out and replace it.
10. Reconnect a new ignition coil. Tighten the fastening screws to 10 Nm (7.5 ftlb.).
NOTE: A rag should be placed between the secondary air pump and the design cover to prevent the cover from being scratched.
11. Install bracket for the torque support. The M8 x 45 Torx screws are tightened on the upper screw points to 23 Nm (17 ftlb.). On the lower screw
points (center of the valve cover), the M6 x 40 screws are first tightened to 5 Nm (3.5 ftlb.) and then to 10 Nm (7.5 ftlb.).