Cayenne S (9PA) V8-4.5L (2003)
/v8-4.5l/Page-1333002.png)
Caution! Damage can result from Pentosin CHF 11 S getting onto the surrounding area (e.g. onto the coolant hoses) when the oil coolant
hoses are released (opened)!
^
Collect any emerging Pentosin.
^
Wear protective goggles when carrying out overhead work on lines with Pentosin!
^
Wear protective gloves!
^
If coolant hoses come into contact with Pentosin, thoroughly clean them with water IMMEDIATELY!
^
Replace visibly swollen coolant hoses!
-
Jack the vehicle and raise at the prescribed support points.
-
Remove front bottom guard.
-
Remove front spoiler.
1. Remove side air guides and the air guide at the top.
2. The bottom air guide does not have to be removed. Remove retaining bracket (front spoiler bottom guard) and move the bumper into the service
position.
3. Use an appropriate collecting bottle for any Pentosin which runs out. Release hoses from oil cooler and close with suitable plugs. Remove the oil
cooler mount, only screwed on the left-hand side.
4. Remove cooler module mounts on left and right. Then unclip the oil cooler from the mount .
5. Carefully pull the -retaining frame for the water cooler- forwards.
6. Carefully push the cooler module back. Pull the -cooler for power steering- out between the cooler module and the retaining frame for the water
cooler.
Installation
