Cayenne S (9PA) V8-4.5L (2003)
^
The entire threaded joints of the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is raised with a universal vehicle lift. Dimension -X-, from Control value: 502 mm ± 10 mm corresponds to vehicle position.
^
Carry out a visual inspection of all parts.
^
Replace self-locking nuts.
^
Replace all expansion screws (screws which are fitted with torque angle tightening procedure).
^
Observe correct tightening torques and torque angle.
^
Make sure the bevel pinions from the ball joints are clean. Clean with a lint-free cloth as necessary. Do not use cleaning agent.
1. Mount the -halves of the stabilizer- on the previously applied marking on the stabilizer. The larger outer diameter of the halves of stabilizer
bearing is on the wheel side.
2. Engage at the prescribed take-up points -arrow-.
3. Position anti-roll bar and fit clamps using the four fastening screws.
4. Fit connecting rod.
Subsequent work
Attach engine guard.
Lower the vehicle.
Removing and Installing Off-Road Stabilizer
Removing and installing off-road stabilizer