Cayenne S (9PA) V8-4.5L (2003)
Information:
^
The entire threaded parts of the axle must be tightened in vehicle position! Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is being raised with a universal vehicle lift. Dimension -X-, from lower edge of wing to middle of axle 506 mm, ±10 mm corresponds
to vehicle position.
^
Visually inspect all parts.
^
Replace self-locking nuts.
^
Replace all expansion screws (screws which are fitted with torque angle tightening procedure).
^
Observe tightening torques.
1. Mount stabilizer bearing halves in the correct position on the stabilizer. In the correct position means: The larger outer [diameter] is on the wheel
side.
2. Engage stabilizer bearing halves at the take-up points provided -arrow-.
3. Insert stabilizer and fit clamps with the four fastening screws. Mount connecting links at stabilizer.
4. Fit the four stabilizer fastening screws in vehicle position.
5. Fit the lines -arrows- and the connector. Fit the lines -arrows- and counter with an open-ended wrench. Connect the connector.