Cayenne S (9PA) V8-4.5L (2003)
^
Replace self-locking nuts.
^
Replace all expansion screws (screws which are fitted with torque angle tightening procedure).
^
Observe tightening torques.
1. Mount stabilizer bearing halves in the correct position on the stabilizer. In the correct position means: The larger outer [diameter] is on the wheel
side.
2. Engage stabilizer bearing halves at the take-up points provided -arrow-.
3. Insert stabilizer and fit clamps with the four fastening screws. Mount connecting links at stabilizer.
4. Fit the four stabilizer fastening screws in vehicle position.
5. Fit the lines -arrows- and the connector. Fit the lines -arrows- and counter with an open-ended wrench. Connect the connector.
Caution:
Increased risk of accidents if the wheel carrier is raised improperly!
^
Injury and material damage possible.
-> Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
-> When raising the suspension, use a suitable intermediate layer (hard rubber).
-> Do not damage the brake cover plate.