Cayenne S (9PA) V8-4.5L (2003)
3. Undo the four fastening screws and remove the clamps.
4. Mark the installation position -arrow- of the stabilizer bearing halves with respect to the stabilizer with a paint marker.
5. Carefully pull out the stabilizer.
Installing off-road stabilizer
Caution:
Increased risk of accidents if the wheel carrier is raised improperly!
^
Injury and material damage possible.
-> Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
-> When raising the suspension, use a suitable intermediate layer (hard rubber).
-> Do not damage the brake cover plate.
Information:
^
The entire threaded parts of the axle must be tightened in vehicle position! Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is being raised with a universal vehicle lift. Dimension -X-, from lower edge of wing to middle of axle 506 mm, ±10 mm corresponds
to vehicle position.
^
Visually inspect all parts.