Cayenne S (9PA) V8-4.5L (2003)
/v8-4.5l/Page-1455008.png)
^
Use an intermediate layer (hard rubber). Do not damage the brake cover plate.
^
Screws and nuts are Dacromet-coated and must not be greased.
^
Grease axle nut with a little Optimoly TA aluminum paste only at mounting-face ring.
^
Grease the toothing of the drive shaft with aluminum paste Optimoly TA.
^
Drive shafts must not be left hanging from the joint stop. Tie up.
^
Use new screws and fastening nuts.
^
Ensure that ball joint rod conical seats are clean. If necessary, clean with lint-free cloth. Do not use cleaning agent.
^
The wheel bearing seat must be free of grease.
^
Use correct tightening torques.
1. Fit the wheel bearing (tools).
^
Check that the bearing seat (in rear axle figure) is clean and the surface is in good order. There must not be scores, grooves or deformations.
^
Insert the wheel bearing with the magnetic multiple-pole ring to the drive shaft. Check the magnetic side (e.g., with a paper clip). Do not use
magnets or screw drivers to check!
2. Position the -wheel bearing in the wheel bearing housing- in the correct position. Position the pressure piece T10205/7 in the correct position on
