Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
pressure pieces again.
-
Maximum assembling force must not exceed 60 KN at the stop.
Lower trailing arm with rubber-metal mounts A, B, C
-
The three rubber-metal mounts -A,B,C- must be replaced once the trailing arm is removed.
The pressure pieces and the tubular piston cylinder VAS 6178 are used for removal. This involves screwing pressure head T10205/13 into the tubular
piston cylinder. T10230/2 is screwed on to the threaded rod and positioned in T10205/13 for pressing bearings in and out. Nut T10230/15 and washer
T10230/14 are screwed onto the opposite end of the threaded rod.
The following pressure pieces and nuts are required for bearings -A-:
Pressing out:
Tools for pressing out hydraulic/rubber-metal mounts
-
T10230/2
-
T10230/7
-
T10230/9
-
T10230/10
-
T10230/14
-
T10230/15
Information
When using the pressure pieces, the direction arrow shows the direction for pressing the rubber-metal mounts in or out on the trailing arm.
The pressure pieces are used as follows: