Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Stabilizer Bar: Service and Repair
Removing and installing stabilizer
Preliminary work
Caution
Increased risk of accidents if the wheel carrier is raised improperly!
^
Danger of injury and risk of damage to property.
-
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
-
When raising the suspension, use a suitable intermediate layer (hard rubber).
-
Do not damage the brake cover plate.
1. Raise the vehicle.
2. Remove exhaust system.
Removing stabilizer
Component overview - anti-roll bar
Component overview - anti-roll bar
1 - Anti-roll bar
2 - Anti-roll-bar mount
3 - Clamp
4 - Fastening screws
5 - Connecting rod
6 - Fastening nut
7 - Fastening screw
1. Release connecting rod at anti-roll bar on left and right. To do this, use a suitable lift to raise the wheel carrier so far that the pin of the connecting
rod can be pulled easily out of the anti-roll bar. Use a suitable lift with rubber base -see figure- to prevent slipping.