Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Installing front-axle carrier
Installing front-axle carrier - V8
Caution:
Heavy components
-
Risk of squashing
-
Wear personal protective gear.
-
Get someone to help if necessary.
Caution:
Heavy components
-
Risk of squashing
-
Wear personal protective gear.
-
Get someone to help if necessary.
Information
-
Before installing, give the parts a visual check.
-
Note previously applied markings on the front axle carrier and on the cardan shaft.
-
A second worker is required in order to avoid damaging adjacent components when fitting the front axle carrier.
-
When fitting the ball joints, ensure that the bevel pinions are clean! Remove dirt or grease on bevel pinions, e.g. with a lint-free cloth. Do not use
cleaning agent/solvent.
-
Replace all fastening nuts and all expansion screws (screws which are fitted with torque angle tightening procedure).
-
The entire threaded parts of the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is raised using a universal vehicle lift. -Dimension X-, corresponds to vehicle position. - Check dimension: 502 mm ±10 mm
-
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels). When raising the suspension, use a suitable
-intermediate layer (hard rubber)-. Do not damage the brake cover plate.
-
Bleed power-assisted steering.
-
Observe correct tightening torques.
-
Align vehicle.