Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
/v8-4.8l_turbo/Page-772009.png)
-
Use the -Porsche System Tester- to calibrate the steering-angle sensor.
-
Perform a function test
Installation is carried out in reverse order.
These removal and installation instructions apply to vehicles with level adjustment and steel springs. The points relating to level adjustment are not
relevant for vehicles with steel springs.
1. Position the -front-axle carrier- on the mounting frame.
2. Pre-fit the accessories on the front axle carrier (steering, final drive, anti-roll bar). Get another worker to help.
3. Position the front axle carrier back in the original, marked installation position and be careful not to damage adjacent parts.
4. Tighten the four fastening screws to the prescribed tightening torque.
5. Remove the -workshop trolley- with the mounting frame and secure the water hose holders.
Front axle carrier
6. Fit the steering gear to the steering column and connect the hydraulic lines.
7. Fit the cardan shaft at the points marked.
8. Install the drive shafts.
9. Fit the tie rod ends. The tightening torque for the fastening nut for attaching the tie rod end is 70 Nm (52 ftlb.).
10. Fit the engine guard and the front wheels.
