Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
/v8-4.8l_turbo/Page-777009.png)
Preliminary work
1. Remove cowl panel.
2. Remove the relevant engine compartment side cover.
3. Remove hub cap using puller hook 9229 and undo drive shaft fastening at the side of the wheel before raising the vehicle. Operate the brake whilst
doing so (second fitter required).
4. Remove wheel.
Removing front spring strut
The air springs are installed as standard in the Cayenne Turbo and are optional in the Cayenne S. The steel springs are not applicable for the Cayenne
Turbo.
