Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
-
Read out the fault memory again.
5. Fit trim panel at the left and rear.
Subsequent work for RA valve block
1. Top up and check the fluid level.
2. Allow the engine to run for approx. 10 minutes (scavenging the system). Then connect the PIWIS Tester.
3. Select the Cayenne PDCC menu item and work through the following points in sequence. Follow the instructions on the PIWIS Tester:
-
Calibration ] Pressure sensor calibration.
-
Perform reset.
-
Select Drive links ] Valve timing.
-
Select Drive links ] Bleed.
-
Drive links ] Perform system test.
-
Read out and erase fault memory.
-
Perform a test drive.
-
Read out the fault memory again.
4. Fit trim panel at the left and rear.