Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
/v8-4.8l_turbo/Page-532005.png)
12. Push the protection over the drive shaft and release the drive shaft at the transmission.
13. One worker must carefully pull upper wheel carrier out and turn the steering. The second worker must carefully pull out the drive shaft.
Installing front drive shaft
Caution:
Wheel carrier raised incorrectly
-
Risk of squashing
-
Risk of damage to components
-
Wear personal protective gear.
-
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
Information
-
The entire threaded parts of the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is being raised with a universal vehicle lift. -Dimension X-, from - Control value: 502 mm ±10 mm corresponds to the vehicle position.
-
Use an intermediate layer (hard rubber)! Do not damage the brake cover plate.
-
Screws are Dacromet-coated and must not be greased.
-
Grease axle nut with a little Optimoly TA aluminium paste only at mounting-face ring.
-
Grease the toothing of the drive shaft slightly with aluminium paste Optimoly TA.
-
Drive shafts must not be left hanging from the joint stop. Tie up.
