Cayman (987) F6-2.9L (2009)
Rear Knuckle Alignment Link: Service and Repair
Removing and installing rear tie rod (toe control arm)
Preliminary work
1. Raise the vehicle.
2. Remove the wheel.
Removing and installing rear toe control arm
Removing toe control arm
1. Remove toe control arm -1- on the wheel bearing housing -1b-.
Use the press-out tool 9560 for pressing out the ball joint. When loosening the lock nuts, counter at the wheel bearing housing -1b- with a
screwdriver 9546 (Torx screwdriver) at the ball-joint pin.
Rear toe and transverse control arm
2. Remove toe eccentric threaded joint on the rear-axle carrier side section. Mark the basic position of the toe eccentrics on the rear-axle carrier side
section.