Panamera S (970) V8-4.8L (2010)
Hood Latch: Service and Repair
Removing and Installing Upper Part of Front Lid Lock
Removing And Installing Upper Part Of Front Lid Lock
Technical values
Removing upper part of front lid lock
1. Open front lid.
2. Screw off fastening nuts -1- .
3. Remove upper part of lid lock -2- .
Installing upper part of front lid lock
INFORMATION: The self-locking nuts must always be replaced.
1. Roughly position upper part of lid lock -2- .
2. Screw on fastening nuts -1- but do not tighten them.
3. Lower the lid slowly until the bar -1- for the upper part of the lock is touching the lower part of the lock.
3.1. The bar -1- must be centered flush with the slit -2- in the lower part of the lock.
4. Open the lid again.
5. Tighten fastening nuts to the specified tightening torque
-
Tightening torque: 9.7 Nm (7.5 ftlb.).