Panamera S (970) V8-4.8L (2010)
Hood Weatherstrip: Service and Repair
Removing and Installing Front Lid Seal
Removing And Installing Front Lid Seal
Removing front lid seal
INFORMATION: During removal, the seal must not come into contact with hot engine components or adjacent units. This can cause damage to the
seal.
1. Remove front profile seal -1- .
1.1. Open the lid.
1.2. Pull the ends of the front profile seal -1- back off the retaining lugs. -A-
1.3. Carefully pull the front profile seal -1- off the retaining flange.
1.4. Remove front profile seal -1- towards the engine. -B-
2. Remove rear profile seal -1- .
2.1. Lift up foam corner pieces at the ends of the profile seal.
2.2. Pull the ends of the rear profile seal -1- up and off.
2.3. Remove rear profile seal.
Installing front lid seal
INFORMATION:
-
Before replacing, check the existing seal for signs of damage (areas torn, crushed, etc.). If there are signs of damage, the seal must be replaced.
-
The seal is pressed onto the flange without any additional sealants.
-
During installation, the seal must not come into contact with hot engine components or adjacent units. This can cause damage to the seal.
1. Install rear profile seal -1- .
1.1. Position rear profile seal -1- on the end plate.